Electrolux SG217N User Manual page 9

Table of Contents

Advertisement

Available languages

Available languages

Problem
There is too much frost
and ice.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the
freezer is too high.
The appliance does not
operate.
A large quantity of drops
ice covers the top com-
partment inside the appli-
ance. .
As much as the advice does not lead to result, call the nearest brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Cleaning the evaporator
1. Switch off the appliance.
2. Disconnect the mains plug from the
mains socket.
3. Remove all foods from the freezer and
put them in a fresh place.
4. Move the appliance far from the wall.
5. Leave the door open.
Possible cause
Food are not wrapped properly.
The door is not closed correctly.
The door gasket is deformed or
dirty.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The food temperature is too high. Let the food temperature decrease
Food is too near to each other.
Large quantities of food to be fro-
zen were put in at the same time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The door has been open to long. Close the door.
There is too much frost and ice on
the evaporator of the appliance,
the door was open for too long
time.
Wrap the food better.
Refer to "Closing the door".
Refer to "Closing the door".
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
to room temperature before stor-
age.
Store food so that there is cold air
circulation.
Insert smaller quantities of food to
be frozen at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Refer to "Cleaning the evaporator".
6. After approximately 20 minutes the drain
hose at the rear of the cabinet starts to
discharge water into the drip tray.
7. To prevent the water overflowing from
the drip tray dry with a sponge.
electrolux 9
Solution

Advertisement

Table of Contents
loading

Table of Contents