AEG SCT81900S0 User Manual page 18

18 www.aeg.com
Problem
The compressor does
not start immediately
after pressing the
FROSTMATIC or
COOLMATIC button,
or after changing the
temperature.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is too
high.
The temperature in
the freezer is too
high.
REPLACING THE LAMP
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter.
Possible cause
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
FROSTMATIC or COOL-
MATIC functions switched
on.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
Products are too near to
each other.
CLOSING THE DOOR
1.
2.
3.
Solution
The compressor starts after
a period of time.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait to set the temperature
until the function has reset
automatically. Refer to
"FROSTMATIC or COOL-
MATIC function"..
Set a higher/lower temper-
ature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Clean the door gaskets.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.