Profi Care PC-MD 3005 Instruction Manual page 27

Initial Operation
1. Connect the power supply plug with the power supply
socket on the bottom of the appliance. Insert the cable
into the cable duct so that the appliance cannot tilt over.
2. Take the water tank off the appliance base. Remove the
lid.
3. Fill the water container with water. Do not fill water above
the 600 ml marking. Close the water tank with the lid.
Place it back onto the unit base. Press the water container
firmly down. To avoid unwanted water discharge, it must
sit flush with the unit base.
4. Plug the power adaptor into wall outlet.
5. Turn on the appliance with the on / off switch
6. Remove the handle of the unit base. Hold the opening
above a wash basin.
7. Switch the regulator to level 10.
8. Unlock the water stop switch by sliding it to position I.
9. Let the water run directly into the wash basin to remove
possible residues. Then lock the water stop switch by
sliding it to the position O.
10. Turn off the appliance.
11. Briefly rinse off the nozzles under running water.
Your oral irrigator is now ready for use.
WARNING:
• Turn off the appliance and disconnect the mains adapter from the
mains supply when cleaning.
• Do not immerse the appliance and the mains adapter into the wa-
ter. It could result in an electric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any sharp or abrasive cleaners.
1. Pour out the remaining water from the water container.
2. Press the release button and pull the nozzle off the han-
dle. Clean the nozzles under warm running water. Dry off
the nozzles and put them back into the lid.
3. If you have used water additives, rinse the water con-
tainer with clear water. Then let ca. 300 ml clear water
run through the appliance as described under "Initial
PC-MD3005_IM_new2
Before using the water jet you should clean your teeth with a
toothbrush.
1. Insert the nozzle onto the handle as far as possible. It
must audibly engage. Turn the nozzle so that its opening
points to the water stop switch.
2. Fill the water container with water which is hand warm.
WARNING:
Do not fill it with hot water!
3. In order to clean the nozzles, allow water to flow through
the nozzle head (at maximum water pressure) into the
.
wash basin before and after each time the appliance is
used.
4. Select the desired water pressure
off switch. Begin on the smallest setting, especially if you
have problems with bleeding of the gums or when the
water jet is used by children.
5. Unlock the water stop switch on the handle.
6. Lean over the wash basin. Guide the water jet along the
gums, around the teeth. Clean all four parts of your mouth
in this way for approx. 30 seconds each. The appliance
will indicate these intervals by short interruptions. After 2
minutes, the appliance will turn itself off automatically.
7. Lock the water stop switch after the application. Select the
minimum water pressure.
8. Put the handle back onto the magnetic holder.
9. Turn off the appliance.
10. Please clean the appliance as described under
"Cleaning".
Cleaning
Operation". Dry off the handle before you put it back onto
the holder on the appliance.
4. Dry off the water container.
5. Clean the unit base with a moist towel. Then wipe it dry.
Usage
by turning the on /
06.11.17
27