Testing Your Fence Operation; Troubleshooting Tips - Pet Stop Comfort Contact PCC-200 Owner's Manual

Owner's Guide
STEP 4

Testing your fence operation

It is important to test that your system is
functioning properly before burying the
boundary wire. You will be looking to en-
sure that the fence is activating properly
at the boundary locations, as well as look-
ing for unwanted signals in the house and
other safe areas of the home.
1. Install the supplied battery in your pet's
training collar. Remove the battery
cover screw cap, insert the battery and
ensure that the positive end is closest
to the battery compartment open-
ing. Replace the battery cap.
note - the light on the collar should not be
illuminated. If the collar light is flashing red
the battery is low and needs to be replaced.
2. Ensure that the fence wires are
properly inserted into the wall-mount
transmitter and the adapter is plugged
into the side of the transmitter and wall
outlet. The
transmitter
display should
illuminate.
3. Hold the
pet's training
collar by the
nylon strap as
shown at approximately the height of
your pet's neck.
4. Slowly approach your outside boundary
loop wire and listen carefully for the
warning beeps. Should you hear the
warning beeps, back up and try different
parts of the boundary area ensuring that
the collar is activating properly in other
locations. If the collar activates too far,
or too near the fence wire, adjust the
signal field setting (see STEP 6).
MKTG0715_063_E_Comfort Contact Owners Guid-PS.indd 7
PCC-200
5. Walk back and forth over the twisted
wire listening for any warning beeps.
There should be none.
6. Walk around the "safe" areas of the
yard and house listening for any warn-
ing beeps. Again, there should be no
response from the pet's collar when
further than 10' from the boundary loop.

TROubLEShOOTING TIPS

The collar will not activate at the bound-
ary loop:
• T he training collar's battery has been
installed in the proper orientation and
*Please the cap has been secured.
• T he wall-mount transmitter has the wire
that runs from the outside loop secured
in the wire connectors and the transmit-
ter is plugged in to the wall outlet.
• T he boundary loop is connected to the
twisted wire running to your transmitter
using the supplied waterproof splices
and that there is only TWO ends of wire
inserted into each splice.
• C heck to determine if your pet fence
system is installed in close proximity to
a neighboring system. If so, see STEP 6:
System Adjustments and Programming.
• M ake sure that your collar battery is
good. If the collar light is flashing red the
battery is low and needs to be replaced.
• S hould you continue to encounter
difficulties, please call your Pet Stop
Professional.
The collar activates in safe areas of the
yard or home:
• C heck that the wire is not running close
to outside utility lines and move where
necessary.
7
7/21/15 12:26 PM