Sakura SS3604 User Manual

12V Digital
Air Compressor
Read these Operating Instructions carefully before use.
Keep these instructions for later reference.
Always operate the Compressor according to these instructions.
To Operate Important Safety Information
Note
1. Connect the Valve to tyre air valve
and push down the Valve Lock
Lever to secure the connection.
2. Connect the 12V plug, the light and
the digital display will operate.
3. Press the 'M' button to change to
the required pressure units.
4. Press and hold the'+' or'-' button
to set the desired pressure.
5. Turn the power switch on to begin
inflating. The compressor will stop
when it reaches the preset
pressure.
6.
Turn the power switch off and
disconnect the 12V plug.
CAUTION: DO NOT over inflate!
• Compressor: Use 12V DC only.
• Make sure that your vehicle
cigarette lighter is free of any ash
residue or debris. A dirty cigarette
lighter can cause the compressor
and power cord to overheat.
Overheating can cause damage to
your compressor/vehicle and
could cause bodily harm or injury.
• Disconnect power when not in use.
• This air compressor is designed
to inflate car tyres, bike tyres,
sports equipment, air beds, beach
_ toys and other inflatables. DO
NOT use for any other purpose
than inflating. If you do so, bodily
harm or personal injury can occur.
• When operating your compressor
DO NOT run for more than 10
minutes continuous use. Allow
compressor to cool down for 10
minutes before re-using.
• After using, disconnect the 12V plug.
• The compressor is not a toy. Keep
away from children at all times.
• DO NOT carry compressor by air
hose or power cord, damage may
occur.
• DO NOT leave the compressor
unattended while in operation.
• DO NOT over-inflate. Be sure to
follow the manufacturers instructions
for the item you are inflating.
• Keep the compressor away from
flammable areas/liquids at all times.
• DO NOT operate the compressor in
wet or damp areas.
• Operate the compressor only with
the accessories that are included.
• This compressor operates only on
12V DC.
• DO NOT attempt to operate this
compressor with any other source
or voltage.
• DO NOT rewire or reconfigure
compressor from its original
design or personal injury or bodily
harm may occur.