Step 3: Configure Pstn Trunk Settings - AudioCodes Mediant Series Quick Setup Manual

4.3

Step 3: Configure PSTN Trunk Settings

This step shows how to configure PSTN trunk settings.
4.3.1 Step 3a: Configure the BRI PSTN Interface
This step shows how to configure the BRI PSTN Interface. Skip to the next step if you have
a PRI interface.

To configure the BRI PSTN interface:
1. Open the Trunk Settings page (Configuration tab > VoIP > PSTN > Trunk Settings).
2. Configure following parameters:
Protocol Type
ISDN Termination Side
BRI Layer2 Mode
Q931 Layer Response Behavior
Outgoing Calls Behavior
Incoming Calls Behavior
Select Receiving of Overlap Dialing
3.
Repeat for all BRI ports available on the device (Mediant 500L)
AudioCodes Mediant BRI/PRI Gateway
Parameter
Figure 4-10: Configuring BRI PSTN Interface
26
BroadCloud SIP Trunk
Value
BRI EURO ISDN
Network side (for BRI PBX connection) or User
side (for PSTN Fallback connection)
Point To Multipoint
0x8000000
0x0
0x11000
Local Receiving
Document #: LTRT-12393