First Use - U-Line OFZ124 Quick Start Manual

Outdoor collections
Table of Contents

Advertisement

QUICK START GUIDE

First Use

CRESCENT ICE MAKERS
Initial startup requires no adjustments.
U-Line recommends discarding the ice produced
during the first two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
To turn the unit on or off:
Press the rocker switch located inside the door on the
front panel, or behind the grille.
REFRIGERATORS
Initial startup requires no adjustments. If the unit was
turned off, press and hold
on. See "Control Operation" section for more details.
Temperature displayed reflects actual
temperature inside unit.
If the temperature displayed is different than selected, the
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set point before
loading.
for 5 seconds to turn unit
CONVERTIBLE FREEZER
Initial startup requires no adjustments. If the unit was
turned off, press
on. To turn off, press
OPERATION section for more details.
Temperature displayed reflects actual
temperature inside unit.
If the temperature displayed is different than selected, the
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set point before
loading.
Approximate time required (empty unit) when converting
between refrigerator and freezer:
38ºF to 0ºF - 1 hour
0ºF to 38ºF - 4 hours
CLEAR ICE AND NUGGET ICE MACHINES
Initial startup requires no adjustments. See CONTROL
OPERATION section for more details.
U-Line recommends discarding the ice produced
during the first two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
When plugged in, the unit will begin operating under the
factory default settings. If the unit was turned off during
installation, simply press
switch on. To turn the unit off, press
22
and the unit will immediately switch
and release. See CONTROL
and the unit will immediately
and release.
u-line.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nugget

Table of Contents