1. Unscrew the hose from the front connector.
2. Remove outer inlet filter and crossed cover of the rear cover (Fig. B).
3. Connect the hose to the rear cover connector (Fig. C) and attach square nozzle.
4. ALWAYS keep air bleed intake hole on the hose open when vacuuming in order to prevent
overheating motor (Fig. D).
5. IMPORTANT! Cleaning Dryer Dust Case, Rear Cover and Filters is required BEFORE converting
unit back to dryer. See maintenance section for complete cleaning instructions. Serious damage
to the motor can occur in drying mode if clean filters and dust case are not in place.
• Important: Always keep air bleed hole on the hose open when vacuuming in order to
VACUUM OPERATION
Fig. B
prevent overheating of the motor. This hole is usually closed when drying.
Fig. C
- 6 -
Fig. D