Asus S2 Series E-Manual page 15

USB 3.1 Gen 2 Type-C™ DisplayPort/Power Delivery
combo port
Use a USB Type-C™ adapter to connect your LED projector to
a compatible device to stream media contents. This Power
Delivery output port provides up to 5V/1.5A of output
voltage and current when a power source is connected to
the Power (DC) input port. You can connect your mobile
device to this port to keep it charged while using it with your
LED projector.
NOTE: Ensure to use USB cables certified by the USB-IF to be
compliant with USB 3.1 Gen 1 or above.
Manual reset hole
If your LED projector is unresponsive, insert a straightened
paper clip into this hole to turn off your LED projector, then
press the power button to turn on your LED projector again.
Remote sensor
The remote sensor detects signal from your LED projector's
remote control, allowing you to access the LED projector's
control panel from a distance of up to 8 meters and a
receiving angle of ±30 degrees.
Power button
Press this power button to turn on or turn off your LED
projector.
LED projector E-Manual
15