Levelling; Reversing The Door - AEG Electrolux S17TK58 Operating Instructions Manual

Levelling

The appliance must be level. Level the appliance by adjusting the two adjustable feet
(1) at the front of the appliance.
If required the washer (2) can be
removed.

Reversing the Door

The side at which the door opens
can be changed from the right
side (as supplied) to the left side,
if the installation site requires.
Warning! When changing the
side at which the door opens, the appliance must not be connected to the
mains. Remove plug from the mains beforehand.
Carefully tilt the appliance to the back and place an adequate object under
it.
Take care to avoid the compressor or the condenser touching the ground.
Unscrew both adjustable legs at the front.
Dismount the door holder at the bottom on the right side. For this, drive the
three screws out, and pull the
door holder down together with
the door holder pin. Remove the
screw on the left side, and drive it
in on the right side.
Remove the door by pulling it
downwards while keeping it
slightly opened.
Unscrew the upper door holder,
and screw it in on the opposite
side.
2
1
31