King Canada Power force KCG-300CS Instruction Manual page 6

ASSEMBLY
Chute Deflector
1. Install the chute deflector (A) Fig.1 to the impeller housing using 2 hex. bolts and
washers (B).
Chipper Chute
1. Install the chipper chute base (C) Fig.1 to the impeller housing using 3 washers
and nylon hex. nuts (D).
2. Pivot chipper chute (A) Fig.2 forward and secure it in the "operation" position using
the lock knob (B). Tighten lock knob.
Upper Hopper & Handle
1. Install the upper hopper (A) Fig.2A and the handle (B) to the hopper (C) using hex.
bolts, washers and nylon hex. nuts (D & E).
Installing Collection Bag
It is not recommended to operate the Chipper/Shredder without the collection bag (A)
Fig.3 installed to the chute deflector (B). To install collection bag;
1. Place the opening of the collection bag (A) over the chute deflector (B) and the
metal tabs (C) so they are covered.
2. Pull on the drawstring (D) until the collection bag is tight around the chute deflector
opening.
INITIAL SETUP BEFORE OPERATION
ENGINE OIL LEVEL
wARNING! This engine has been shipped from
the factory without oil or very little oil in the
crankcase. Operating your engine without the
correct amount of oil can damage it. Oil
crankcase capacity: 0.6 litres.
Always check the oil level before starting the engine, make sure the engine is
on a level surface. To check oil level;
1. Turn the oil gauge dipstick (A) Fig.4 counterclockwise, remove it and clean it with
a clean cloth.
2. Fully reinsert the oil gauge dipstick and pull it out to check the oil level.
3. If the oil level is halfway up the dipstick or below, refill with SAE 10W30 oil through
the dipstick hole until the oil level reaches 3/4 up the dipstick or until it reaches the
bottom lip of the dipstick hole as shown in the illustration above.
4. Reposition the oil gauge dipstick and tighten it by turning clockwise.
ASSEMBLY& INITIAL SET-UP
BEFORE OPERATION
Figure 3
Figure 1
Figure 2
Figure 2A
Figure 4