Specifications - King Canada Power force KCG-300CS Instruction Manual

1. Hopper. Place leaves, twigs and branches up to 1/2" in
diameter for shredding.
2. Chipper chute. Place branches up to 3" in diameter for
chipping.
3. Chute deflector. All shredded or chipped material will
come out of the chute deflector, it is recommended to
install the collection bag to the chute deflector.
4. Chipper chute lock knob. For storage purposes, it is
possible to unlock chipper chute and pivot it backwards.
Lock knob and chipper chute must be locked before
operating.
5. Oil gauge dipstick. Check the oil level using this oil gauge
dipstick.
6. Power ON/OFF switch. This switch must be switched to
"ON" before pulling recoil starter.
7. Recoil starter. Starts the engine.
8. Fuel Shut-off Valve. Regulates the flow of fuel to the
engine. The fuel shut-off valve must be fully opened before
starting the engine.
9. Choke lever. Once the engine is started, it is necessary to
gradually move the choke lever to the "OPEN" position,
see instructions futher in this manual. On warm starts,
choke is not needed.
10. Carburetor throttle lever. Once the engine is started,
move the trottle lever to increase or decrease engine
speed.
11. Air cleaner element/cover. Periodically the air cleaner
filter must be checked and maintained, see maintenance
section.
12. Muffler. Be careful, the muffler can get very hot during
operation, keep hands away.
13. Fuel cap. Make sure the fuel cap is always screwed on
tightly.
14. Handle. For transport purposes.
MODEL
Chipper maximum diameter
Shredder maximum diameter
Engine (OHV)
Displacement (cc)
Fuel
Fuel tank (L)
Oil capacity (L)
Assembled dimensions (LxWxH)/weight
Package dimensions (LxWxH)/weight
GETTING TO KNOw YOUR
3" CHIPPER SHREDDER

SPECIFICATIONS

KCG-300CS
3"
1/2"
7 HP
208
Unleaded Gasoline
3.6
0.6
32" x 40" x 49" / 165 lbs
39-3/8" x 21-5/8" x 50"/ 200 lbs