Advertisement
INSTALLATION
1. Jack up rear frame and support rider with
wooden blocks or jackstands.
2. If 60 gallon grass catcher is to be installed,'
remove weights and mounting hardware from
rear frame. Retain hardware and reinstall
whenever grass catcher is removed.
3. Remove plastic cap (A, figure I), cotter pin (B),
and washers (C) securing rear wheel. Retain
h a r d w a r e t o r e i n s t a l l w h e e l o n t o n e w
crossmember.
4. Install (verticaf) spindle of support bracket (D)
through rear frame and secure with 3/8-16x 3-
1/2" capscrew (E), lockwasher (F), and nut (G)
on top of frame. Spread uprights of support
bracket as required to install to rear frame,
5. Install 1/2-13x 1-1/4"capscrew
(I), and large flat washer (J, l-1/4" O.D., l/2"
I.D.) through threaded spindle.
6. Install two washers (K, l-1/2" O.D., 1" I.D.) on
support
bracket
spindle
necessary) and install crossmember (R) an
spindle.
While
holdingcrossmemberfirmlyonto
spindle, rotate crossmemberfromside toside. If
there is not at least l/16" clearance with frame,
add additional washers (K,asrequired)
crossmember and support bracket.
(more
may
be
10. Install plastic caps (A) over wheel spindles.
11. Lubricate the five grease fittings (2 on wheels, 2
between
12. Adjust tire pressure to 20 psi (137 kPa).
2
7
Place flat washer (L, l-1/2" O.D., 1" I.D.) and,
plate (T) onto spindle and secure with washers,
Use washers (M) as required to fill up space on,
spindle. Tighten castle nut securely and then
back
off
until
crossmember
Check that cotter pin (U) can be installed
through slot in castle nut. Loosen nut until step 8
is performed.
8.
In top hole of plate (T), install l/2-13 x l-1/4",
on support bracket. In bottom hole, install
similar capscrew (0) and secure on backside of
support bracket with lockwasher (P) and nut,
(Q). Tighten capscrews (0), castle nut (N), and
install cotter pin.
9.
Install washer (C, l-1/2"
wheel spindles and install through bushings on
each side of crossmember. On top side, install
as required so that cotter pins
that wheels rotate freely after cotter pins are
installed.
on wheel spindles, 1 on support bracket).
rotates
freely.
O.D., 1" I.D.) onto
FORM -1705847-02
Advertisement
