38" snow thrower attachment three piece frame lt series (14 pages)
Summary of Contents for Snapper 1691530
Page 1
SCREW (Included in Ref. No. A) L-BRACKET (Included in Ref. No. A) I N S T A L L A T I O N INSTRUCTIONS MFG. NO. 1691530 HORN KIT FOR F R O N T - C U T RlDERS FORM - 1702038 PRINTED IN U.S.A.
Page 2
NOTE Not all hardware supplied with horn kit will be used for this installation. Discard excess hardware. Refer to figure 1 to familiarize yourself with the assembly. NOTE On newer gear models, battery is not located in rear compartment (see figure 3). This allows installation by either of the following methods.
Page 3
b. Remove this existing screw, and install new 5/ 16- 18 x 1 screw (F), being sure the retainer is in original position. c. Place the horn assembly into position onto the screw and install the flange whizlock nut(E). The horn should appear as in figure 4.