Advertisement
INSTALLATION - BLOWER ASSEMBLY, 42" & 48" MOWER
1. Remove the right-hand arbor cover (A, figure 7) by
removing bolts, washers and nuts in front that hold
cover to deck. Also, remove nut (9) and washers that
2. Slip mower belt off the right hand pulley. Remove
the pulley from the arbor by removing capscrew
washers. Save washers for re-installation. Use wood
block to prevent blade from turning
Figure 7.
A. Arbor Cover
3 . Remove brake spring or spring anchor (if equipped)
and two self-tapping screws from arbor. Install two
capscrews (A, figure 8).
Figure 8.
A. Capscrews
B. Arbor
Bracket
C. Notch
and
E. Belt Stop. Front
4. Before installing arbor
washer from underneath blade brake bracket (rear
capscrew). Arbor bracket is same thickness as washer
and will replace washer.
Figure 9A: Arbor Bracket and Belt Stop
A. Arbor
Bracket
B. Belt stop
c . Capscraw
5. Install, the arbor bracket (A, figure 9A) and rear belt
stop (B)asshown. Note thedifferent holesforthe42"
and 48" mowers. Tighten nut(G) snug only-belt stop
will be adjusted in step 8.
6. lnstallthefront
removed, reinstall brake spring or spring anchor (F)
before flange nut(G). Tighten nut(E) snug only-belt
stop will be adjusted in step 8.
G
Figure 9B. Front Belt Stop
A. Belt Stop
B
.
F. Spring or Spring Anchor
C. Large Washer
G. Flan@ Locknut
Lockwasher
D.
bracket
E. Large Washer
F. Lockwasher
G. Nut
Mower Decks
Brake
Advertisement
