Advertisement
INSTALLATION - BLOWER ASSEMBLY, 36" MOWER
carriage bolts, lockwashers
hardware for use when blower is removed for side
discharge.
2. Install strap (A, figure I) as follows:
a. Drill a 9132" hole for large spacer (B). Use the
supplied template on the last page. Align template
with deflector mounting holes (C).
b. Install strap (A, figure 1) to
shown in figure 2.
Check
c.
the installation. The strap should
secured to deck with locknut (D, figure 1). The
small spacer (E) should be above the strap. The
large spacer (B) should be between strap and
mower deck.
3. The belt stop (A, figure 3) and hardware must be
relocated to hole (C) shown. Install self-tapping
screw (B). which was removed. in place of belt stop.
Figure 1.
A. Strap
6. Large spacer
C. Holes, Deflector Mounting
D. Nut, Center Lock, 5,,S
Mower Deck
Figure 2.
two
and nuts. Save this
deck
with hardware
be
E. Small Spacer
F.
Pulley
G. Wing Nut
H. Cup
Center
Lock
Figure 3.
A. Belt Stop
C. New Belt Stop Location
To ease installation, engage PTO lever, so that
brake is away from pulley.
4. Remove the existing right-hand arbor pulley and
install the new double-groove pulley (F, figure I)
with existing capscrew, lockwasher and washer.
Torque to 55 to 70 ft. Ibs. Do not reinstall deck-drive
belt at this time.
5 . Install the baffle (B, figure 4) as shown. Installretainer
nut (E) in baffle, then screw the I/4" whizlock screw
(A) into retainer nut. Insert 1/4"caniage bolt (C) from
inside deck and install lockwasher and nut (D).
A. Screw. Whizlock. l/4-20 x l/2
6. Baffle.
C. Bolt, Carriage, l/4-20 x 5/S
D. Lockwasher and Nut, l/4
3
NOTE
Advertisement
