Electrical Connection - Electrolux ENB 35405S User Manual

66 electrolux
freezer door (Fig. 3).
Place the freezer door on the lower
door retaining pin (f) (Fig. 4).
Open doors and fix the double door
mount with 2 screws (c) on the left-
hand side. Don't forget the plastic
spacer under the door (b) as well. The
edges of the doors must run parallel to
the side edge of the appliance.
Place the fridge door on the double
door retaining pin.
Remove the top left-hand side door
mount (f) and the panel (c) from the
plastic bag and attach using the
screws (c) (Fig. 1).
Open the fridge door, attach the top
cover (j) using 2 screws (a); at the
same time pay attention to the
repositioning of the magnet (k), then
close the door (Fig. 2).
Put the appliance into position, make
adjustments if not horizontal and
connect to the electrical supply.
If you do not want to carry out these steps
yourself, please contact the nearest
branded service point. Technicians will
make a charge for door reversal.
GB

Electrical connection

This refrigerator is designed to
operate on a 230 V AC ( ~ ) 50 Hz
supply.
The plug must be put into a socket
with protective contact. If there is no
such, it is recommended to get an
electrician to fit an earthed socket in
compliance with standards near the
refrigerator.
This appliance complies with the
following E.E.C. Directives:
73/23 EEC of 19.02.73 (Low Voltage
Directive)
modifications,
89/336 EEC
(Electromagnetic
Directive)
modifications.
96/57 EEC - 96/09/03 (Energy
Efficiency
subsequent amendments
and subsequent
of 03.05.89
Compatibility
and subsequent
Directive) and its