Electrolux ENZ34700X User Manual page 14

14 electrolux
Problem
The temperature in the
appliance is too cold.
The temperature in the
appliance is too warm.
The temperature in the
refrigeration is too warm.
The temperature in the
freezer is too warm.
The appliance does not
operate.
The lamp does not work.
Door interferes with ven-
tilation grill.
Misaligned door
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
1. Disconnect the appliance from the power
socket.
2. Disassemble the lamp by using a screw-
driver in the recess on the lamp insert.
3. Assemble a new lamp by guiding it into a
centred position and press until it snaps.
Use a halogen bulb of the same type,
maximum rating of 20 W
4. Reconnect the appliance.
Possible cause
The door gasket is deformed or
dirty.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The food temperature is too high. Let the food temperature decrease
There is no cold air circulation in
the appliance.
Large quantities of food to be
cooled were put in at the same
time.
Food is too near to each other.
Large quantities of food to be fro-
zen were put in at the same time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The door has been open to long.
The lamp is defective.
The appliance is not levelled.
The appliance is not levelled.
Refer to "Closing the door".
Set a warmer temperature.
Refer to "Hints for temperature in-
side the fridge.
Set a colder temperature.
Refer to "Closing the door".
to room temperature before stor-
age.
Make sure that there is space be-
tween food to allow air circulation.
Insert smaller quantities of food to
be cooled at the same time.
Store food so that there is cold air
circulation.
Insert smaller quantities of food to
be frozen at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Close the door.
Refer to "Replacing the lamp".
Refer to "Levelling"
Refer to "Levelling"
Closing the door
1. Clean the door gaskets.
Solution