Advertisement
1. To open
a)Pull the retaining clips upward and outward .
b)Lift the cover from the container.
2. Dust bag
Fit the opening on the dust bag over the air inlet. Press the
membrane over the flanged edge on the inlet. Secure with the
lock washer. Use only original dust bags.
3. Hose connection
Push the hose coupling all the way in and turn clockwise.
4. Tubes
Backsaver wand
Fit the two sections together and twist the sections so that the
locking device snaps in locking position in the wand. Note that
you can twist the wands in two different angles. To release the
wands, push the button (1) at the locking device.
Telescopic extension tube
Push down the catch and then adjust the length. Max.950mm,
min.630mm.
4b) Parking clip
During and after cleaning you can park the hose with tubes
and nozzle. Press the parking clip which is plased at the
combination nozzle inside the groove on the back-side of the
container.
5. Tools
The accessories shown in the pictures may vary from model
to model.
a-b) Combination nozzle
Adjust the nozzle according to the requirements of the floor
you are cleaning. Work with the brush on hard floors and
without it on soft floors.
c) Crevice nozzle
Use to clean furniture, radiators and others hard-to-reach
places.
d) Small combi-nozzle
The small combi-nozzle combines a dusting brush for furniture,
picture frames, mouldings etc. with a fold-out nozzle for clea-
ning curtains, furniture and other soft surfaces.
6. Suction control
The suction control in the hose handle lets you regulate the
air-flow to prevent the nozzles from fastening to the surfaces
you are vacuum cleaning.
INSTRUCTIONS FOR USE
7. Start/Stop
a)Foot-operated on/off switch.
b)Plug-in point for powered carpet nozzle. Power is sup-
plied to the socket when the machine is switched on.
8. Warning!
Never attempt to vacuum liquid, glass fragments or ashes!
Wet surfaces can expose the operator to possible electri-
cal shock.
9. Filter
The filters are located inside the lid. To reach them lift out
the filter holder(a). The standard filter(b) and fine filter (c)
should be inspected at regular intervals,e.g. when you
change dust bags, and replace if necessary.Instead of
these two filters you can fit a micro filter of HEPA-quality
(e), wich traps 99,99% of all particles larger than 0,3
microns. The machine is also fitted with a backupp filter (d)
located above rhe motor. This filter should also be inspec-
ted and replaced if necessary.
IMPORTANT!
Your vacuum cleaner is equipped with a specially de-
signed cable, which if damaged, must be replaced by a
cable of the same type. These cables are avaible at
authorized service shops and must be installed by trained
personnel.
Your vacuum cleaner is equipped with a thermal cut-out to
protect the motor and other vital machine parts from
overheating. Should the machine cut out, you will have to
wait at least 5-10 minutes for it to automatically reset.
While you are waiting, switch the machine off and unplug
it, then check the hose, dust bag and filters to be sure that
nothing is blocking the flow of air through the machine.
Remove the plug from the socket before performing
service or maintenance.
NB!
7
Advertisement
