Table of Contents
Advertisement
a) Door
The dimensions of the door should be:
- width
595-598 mm
- thickness
16-22
The height (C-Fig. C) depends on the height of the adjacent furni-
ture's base.
b) Hinges
To mount the hinges it is necessary to drill two holes (dia. 35 mm,
depth 14 mm) on the inner side of the door. The distance between
the holes must be 416 mm.
The distance (B) from the lower part of the worktop to the centre
of the upper hole is approx. 178 mm.
This is not a precise dimension since adjacent furniture also has
to be taken into account. The door height can be adjusted by
+/- 3.5 mm by means of the hinges.
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of screws for wood
(2-Fig. B).
HOLE DIA. 35 mm - Depth 14 mm
P0026
c) Mounting the door
Fix the hinges to the machine by means of the M5x9 screws
(3-Fig. B). The hinges can be adjusted to compensate for possible
uneven thickness of the door.
To align the door perfectly it is necessary to loosen the screw
(3-Fig. B), adjust the door and tighten the screw again.
124
mm
C
Advertisement
Table of Contents
