Installation - Screen Innovations Solo Installation Instructions Manual

6. Hang the Solo on the mounting brackets with the
disks in the back channel. The Solo will have to be
tilted slightly so that the disk edge will engage the
top groove in the cassette channel on the back of the
Solo. If the Solo has a low voltage motor (non-
battery motor), connect the low voltage supply
leads to the short leads coming from the back of the
cassette.
Installation / Step 6
Back Screw
Set Screw
Pg 7
7. Once hung, slide the Solo horizontally to fine tune
the centerline alignment.
8. Tighten the set screws to lock the Solo in the
channel.
9. Tighten the back screws on the ceiling mount
brackets to lock the Solo to the brackets.
Installation / Step 7 - 9 Pg 8