Section 2:Installation; Removal Of Transportation Screws - Smeg SWM65 User Manual

•
If you will not use your machine for a long time, unplug your machine,
close the water supply and leave the door open in order to keep the
inside of the machine dry and for prevention from unpleasant odour.
•
As a result of the quality control procedures, a certain amount of
water may remain in your machine. This is not harmful for your
machine.
SECTION 2: INSTALLATION
You must pay attention to the following issues before using your washing
machine.

REMOVAL OF TRANSPORTATION SCREWS

•
Transportation screws, which are located at the back side of the
machine, must be removed before running the machine.
•
Loosen the screws by rotating counterclockwise by a suitable wrench.
(DIAGRAM-1)
•
Remove the screws by pulling them.(DIAGRAM-2)
•
To the holes where the transport screws have been removed, insert
the plastic transport screw taps found in the accessories bag.
(DIAGRAM-3)
•
The transportation screws, that have been removed from the machine
should be kept in hand for any other transportation necessities.
DIAGRAM-1
DIAGRAM-2
3
DIAGRAM-3