SAFETY WARNINGS AND GUIDELINES Please read this manual thoroughly, paying extra attention to these safety warnings and guidelines. Keep this manual in a safe place for future reference. Installation and Operation This product should only be installed by a qualified structural contractor. Failure to follow proper structural code in regard to hanging equipment could result in serious injury or death.
General This device is intended for indoor use only. Do not expose this device to water or moisture of any kind. If water does get in or on the device, unplug it from its power source and allow it to fully dry before reapplying power.
AC power plug, ensure that the power outlet is readily accessible so that power can be removed in the event of an emergency. All wires and cables installed inside the ceiling must be rated for in-wall/in-ceiling use by the UL or a similar certification agency. An in-wall rating is sufficient for residential installations, while a riser or plenum rating is required for commercial installations.
PACKAGE CONTENTS Please take an inventory of the package contents to ensure you have all the items listed below. 1x Motorized projector lift assembly 1x Ceiling cutout template 1x M4 hex wrench 4x M3x20mm screws 4x M4x20mm screws 4x M5x20mm screws 4x Rubber washers 3x Long ribbons 1x 6P-4 power wire clip...
INSTALLATION This projector lift is designed to be installed in the space between a dropped ceiling and the primary ceiling structure. The lift itself need to be mounted to the primary structure, which must be capable of supporting four times the weight of the lift and the projector itself.
Page 9
6. The lift allows you to mount the projector in its normal orientation or inverted. The normal orientation is preferred if the space between the primary ceiling structure and the dropped ceiling surface is limited. Mount the projector to the projector mounting plate.
Page 10
12. Plug the projector lift power cable into a nearby AC power outlet. Ensure that the outlet is readily accessible so that the assembly can be quickly and easily disconnected from power. 13. Mount the RF remote control receiver near the ceiling surface. 14.
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Modifying the equipment without Monoprice's authorization may result in the equipment no longer complying with FCC requirements for Class B digital devices. In that event, your...
right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Need help?
Do you have a question about the 15495 and is the answer not in the manual?
Questions and answers