Wheel Refacing; Specimen Mounting - Taber 5135 Operating Instructions Manual

Wheel Refacing

Part No. Model
121102 S-11
125777 ST-11
980250 250
128990 133-60
125608 200-62

Specimen Mounting

Part No. Model
125560 S-36
129270 S-36-1
125558 S-37
129271 S-37-1
120990 E100-125
125795 E100-101
125796 E100-102
121205 E100-10
121155 E140-14
121148 E140-15
121208 E140-18
121207 E140-19
121206 E140-21
125604 E140-75
132725
121241 E3945
121224 S-21
132690
132705
121016 S-19
Description
Refacing Discs (4" diameter, 150 grit abrasive paper), 100 pc.
Refacing Stone (4" diameter x ¼" thick with ⅛" hole, opposing sides are
80 and 180 grit)
Wheel Refacer [for use with all Rotary Abrasers]
Single Point Diamond Tool for Wheel Refacer, 3/8" – 24 thread (for
980250 s/n 20041462 and later, and 980200-20)
Multiple Point Diamond Tool for Wheel Refacer, 3/8" – 24 thread (for
980250 s/n 20041462 and later, and 980200-10)
Description
Specimen Mounting Cards – 4 ¼" square (one side coated w/pressure
sensitive adhesive, opposite w/test record form), 50 pcs.
Specimen Mounting Cards – 4 ¼" round (same description as S-36), 50
pcs.
Specimen Mounting Sheets – 4 ¼" square (both sides coated w/pressure
sensitive adhesive), 100 pcs.
Specimen Mounting Sheets – 4 ¼" round (same description as S-37),
100 pcs.
Specimen Holder – 4 ¼" O.D. (complete with spring clutch, rubber pad,
nut and clamp plate)
Specimen Hold-down Ring, 4 17/64" I.D.
Specimen Hold-down Ring, 4 21/64" I.D.
Specimen Holder – 4 ¼" O.D. (transparent plastic)
Specimen Holder with Clamp Ring – With Center Screw (S) or without
Center Screw (NS)
Specimen Holder – Textile
Specimen Holder – Textile (rimmed)
Specimen Holder – "Drive Pin" Type
Specimen Holder – Threaded Ring (NEMA)
Specimen Holder – Rimmed
Specimen Holder – Sliding Mount (permits testing of four 2" x 2" square
samples)
Specimen Holder – Multiple Textile
Extension Nut for ¼" to ½" Thick Materials (samples require 3/8"
diameter center hole)
Arm Height Extension Kit, for Model 5135 Single Abraser – test
specimens up to 40mm (includes left & right arm height extenders and
set of 6 shims)
Arm Height Extension Kit, for Model 5155 Dual Abraser – test specimens
up to 40mm (includes left & right arm height extenders and set of 6
shims)
Rubber Pads for Specimen Holder (4 ¼" O.D.), each
49 5135 / 5155 Operating Instructions ver 1.1