Setting The Counter Display; Setting The Test Cycles - Taber 5135 Operating Instructions Manual

2. From the menu options, press 2 to select
Refacing.
3. Enter a new value, and press ENTER to
save.
1-Speed
2-Refacing
3-Display
>Select Menu Option
Change refacing
default cycles:
>Enter new total
>CLEAR key to return
Change refacing
default cycles:
>Enter new total
>ENTER key to save
Change refacing
default cycles:
>Enter new total
>CLEAR key to cancel
Default number of
Reface Cycles
set to
50 cycles
After entering the new value in step 3 and
NOTE:
pressing ENTER, the display screen will flash "Default
number of Reface Cycles set to X cycles" to confirm
your selection and will automatically return to the main
display screen.
NOTE: If
a new value is entered with the numeric
keypad or a Preset Cycles button when the Abraser is
in the Reface Mode, the number of reface cycles will
change. However, this DOES NOT change the default
refacing cycle value.
WARNING:
Do not exceed 50 cycles on an S-11
refacing disc. If more than 50 cycles are required,
replace the refacing disc.

Setting the Counter Display

The Rotary Platform Abrasion tester can be
programmed to show "Completed Cycles" (count
up) or "Remaining Cycles" (count down). The
following explains how to change the display:
1. Press the MENU button to display Menu
Options (see below for screen displays).
2. From the menu options, press 3 to select
Display.
4-Vacuum
5-Outlet
6-Reset
25
50
Alternating
Display
Screens
50
9
3. Using the numeric keypad, enter "1" to
display Completed Cycles or "2" for
Remaining Cycles.
indicates the current counter display.
1-Speed
2-Refacing
3-Display
>Select Menu Option
Current Count Mode=*
*1- Completed Cycles
2- Remaining Cycles
>Press 1 or 2
Change Count Mode=*
*1- Completed Cycles
2- Remaining Cycles
>CLEAR key to return
Counting mode set
to display
Remaining Cycles
After entering the new value in step 3, the
NOTE:
display screen will flash "Counting mode set to display
Remaining (Completed) Cycles" to confirm your
selection and will automatically return to the main
display screen.

Setting the Test Cycles

The Abraser can be preset to any number of test
cycles below the maximum value of 50,000.
The total cycle count shown on the display
screen defaults to the test duration value that
was last entered.
To reset the test cycles, depress the CLEAR
key, and then select the desired number of test
cycles using one of the two options discussed
below. The Abraser turntable will stop
automatically at the selected number of test
cycles. To begin testing a new specimen, press
the CLEAR key. It is not necessary to re-enter
the same value of test cycles at the beginning of
each test.
Option 1: With the Abraser in Run Mode, a
new value may be entered with the numeric
keypad. After the desired number of test
cycles has been entered, press the ENTER or
START key. If an incorrect value is entered,
press the CLEAR key to return to the original
value.
Option 2: The PRESET CYCLES buttons let
you conveniently enter values of 100, 500,
5135 / 5155 Operating Instructions ver 1.1
The asterisk (*)
4-Vacuum
5-Outlet
6-Reset
Alternating
Display
Screens