Taber 5135 Operating Instructions Manual page 19

Sliding Mount Specimen Holder
This holder is designed to test small, rigid
materials. With two adjustable slide mounts,
four 50 mm square samples can be
(2.0 inch)
mounted to this table.
threaded center post, one corner of each
specimen must be trimmed.
Figure 45
Specialty Tables
If your product cannot be evaluated with one of
our standard specimen tables, please contact
Taber Industries directly.
Figure 46
Specimen Clamp Plate
When using the Scuffing Attachment to test
carpeting and other floor covering materials, a
smaller diameter clamp plate 31.75 mm
is available. The smaller diameter helps to
To accommodate the
(1.25 inch)
18
prevent crushing of the specimen fibers near the
wear path.
Specimen Clamp Ring
Two specimen clamp rings are available for the
Taber Rotary Platform Abraser. The standard
clamp ring provided with the instrument is Model
E100-101. This has a 108 mm
and is designed for flexible materials up to 0.79
mm thick. With a 110 mm
(0.0312 inch)
I.D., model E100-102 will accommodate flexible
materials up to 1.59 mm
102 is also referenced as clamp ring "B".
Figure 47
Extension Nut (S-21)
To secure specimens that are 6.35 mm
to 12.7 mm
(0.5 inch)
extension nut should be used.
center hole must be drilled into the
(0.375 inch)
specimen to accommodate the longer shoulder.
For specimens that exceed 12.7 mm
NOTE:
inch) thickness, use the Arm Height Extension Kit (see
Accessory Instruments).
Figure 48
5135 / 5155 Operating Instructions ver 1.1
I.D.
(4.265 inch)
(4.328 inch)
thick. E100-
(0.0625 inch)
(0.25 inch)
in thickness, the S-21
A 9.525 mm
(0.5