Keystone Hardscapes Stonegate Country Manor Fireplace With Curved Walls And Columns Installation Instructions Manual page 10

C O U R S E B Y C O U R S E I N S T R U C T I O N S
Fireplace Installation Note:
The installed fireplace front outside corners of the fireplace insert face should contact the small end
units at the inside end of the two inside walls. If the fireplace insert does not contact the small units at
each side, trim the front and or side units below to allow the fireplace insert to move forward to contact
the small units at each odd numbered course.
10 Keystone Step-by-Step Kits
Fireplace Note:
Install fireplace and chimney components as per
fireplace manufacturers installation instructions.
Block Cutting Note:
Using a concrete saw or wheel grinder tool w/masonry disk, cut block units as needed.
Block units to be cut due to obstruction are labeled with solid hatching.
Block units to be cut to fit are labeled with angular hatching.
Cap Cutting Note:
Using a conccrete saw or wheel grinder tool w/masonry disk, cut block units as needed
Cap units to be cut due to obstruction are labeled with solid hatching.
Cap units to be cut to fit are labeled with angular hatching.
Curved Wall Capping Note:
4th course curved wall capping can be placed after 5th course fireplace/column is in
place (not shown here for display purposes)