Advertisement
Q7751A ROUTERS
1
3
WIRE
ENTRY
TERMINAL
SCREW,
TIGHTENING
TORQUE 4
LBS. IN.
2
1
THREADED SCREW HOLES FOR ATTACHING ROUTER INTERFACE TO
BASE PLATE. USE 8-32, 3/8 IN. SCREW, Echelon 205-0130-01 OR EQUAL.
2
0.230 IN. HOLES FOR ATTACHING BASE PLATE TO ELECTRICAL BACK
BOX OR SUB-PANEL.
3
0.180 X 0.280 IN. HOLE FOR THE ATTACHING BASE PLATE TO
ELECTRICAL BACK BOX OR SUB-PANEL. USE 6-32, FLAT-HEAD,
3/8 IN. MINIMUM SCREW.
4
WRITING SPACE FOR INSTALLER. USE FINE POINT
SANFORD SHARPIE MODEL 30001 OR EQUAL.
Fig. 3. Q7751A rear view of base plate.
The Type 2 base plate is keyed to prevent accidental
insertion of an incorrect module. The router is attached to
the base plate with two 8-32 x 3/8 in. screws (provided).
The Type 2 base plate mounts to either a suitable U.S. four
in. square, two in. deep (10.16 cm x 5.08 cm) electrical
box, U.S. double gang electrical box or an IP-65 (NEMA 4)
enclosure. See Fig. 4 and 5.
95-7511—2
2
4
1
ROUTER MODULE
Fig 4. Four in. square, two in. deep electrical box
M16382
ROUTER MODULE
Fig 5. Double gang two in. deep electrical box
2
4 IN. SQUARE
ELECTRICAL
BOX
BASE PLATE
mounting configuration.
DOUBLE GANG
ELECTRICAL BOX
BASE PLATE
mounting configuration.
M16384
M16385
Advertisement
