Friction Clutch And Mechanical Load Brake With Friction Clutch - Harrington ER2 SERIES Owner's Manual

4)
Remove all chain components including the Bottom Hook Set Assembly, Stoppers, Cushion Rubbers,
Chain Springs, Striker Plates, Chain Pin and End Wire (or End Suspender) from the chain for reuse on
new chain. Inspect and replace any damaged or worn parts.
5)
Using a C-link, attach the new chain to the end link of the old chain on the no-load side. The end link of
the new load chain should be connected so that the welded portions of the load chain's standing links
are oriented to the outside as they pass over the sheave. Refer to
6)
Operate the hoist down to move the chain though the hoist body. Stop when a sufficient amount of
new chain is accumulated on the load side.
7)
Single fall hoists - Attach the chain components (step 4 above) to the chain. Refer to
the proper locations.
8)
Double falls (020C, 030C, 050L) - Feed the end link on the load side of the new chain through the
required chain components (step 4 above) and the bottom hook's Idle Sheave. Attach the remaining
chain components to the chain referring to
the top connection yoke with the chain pin, slotted nut, and cotter pin. Ensure that chain remains free
of twists. Refer to
WARNING
9)
properly installed. Refer to
10)
After installation has been completed, perform steps outlined in
and Trial Operation".
6.6

Friction Clutch and Mechanical Load Brake with Friction Clutch

6.6.1 Friction Clutch (NER2 Models) – If abnormal operation or slippage occurs do NOT attempt to
disassemble or adjust the Friction Clutch. Replace the worn or malfunctioning Friction Clutch as an
assembly with a new, factory adjusted part.
Section 3.2
Section 3.2.6.
Make sure Stoppers, Cushion Rubbers, Chain Springs and Striker Plates are
Section 3.2.
Figure 6-5 Chain Replacement
45
Figure 6-5.
for the proper locations. Connect the end link to
Section 3.7, "Preoperational Checks
Section 3.2 for