Download Print this page

nanoradar NSR100W User Manual

Intrusion detection radar

Advertisement

NSR100W MMW Regional
Intrusion Detection Radar
User Manual
Hunan Nanoradar Science and Technology Co.,Ltd.

Advertisement

loading

Summary of Contents for nanoradar NSR100W

  • Page 1 NSR100W MMW Regional Intrusion Detection Radar User Manual Hunan Nanoradar Science and Technology Co.,Ltd.
  • Page 2 Please strictly follow the manual to install and use the product. Any improper usage may cause damage or injury, and Nanoradar would not bear the corresponding loss and liability. Product copyright is reserved by Nanoradar.
  • Page 3: Table Of Contents

    Contents Brief introduction about NSR100W ..................... 1 Matters of attention in use ........................1 Shipping list ............................2 Quick-to-setup steps ..........................2 Installation instruction ........................ 2 Test and use ..........................3 Frequently asked questions (FAQ) ....................... 5...
  • Page 4: Brief Introduction About Nsr100W

    Much attention should be paid to the " matters of attention ". (1) NSR100W needs to be installed in a stable bracket; (2) When installing NSR100W, the direction of connection cable lines should be toward down, vertical to the ground;...
  • Page 5: Shipping List

    4 Quick-to-setup steps 4.1 Installation instruction NSR100W radar can be fixed by two manners, four pcs of M4 screws to fix red hole site or four pcs of M4 screws to fix blue hole site. Figure 3 Sketch diagram of NSR100W installation screw hole The radar is mounted directly in front of the perimeter area and the radar antenna plane is faced up to the right center of the perimeter zone.
  • Page 6: Test And Use

    Figure 5 Sketch diagram of NSR100W installation 4.2 Test and use NSR100W sensor performance data can be acquired and parsed by the "MMW Radar General Management Tool "testing software, which is used to visually display the observation results. The tool is helpful in the use of NSR100W sensor.
  • Page 7 Figure 6 NSR100W diagram for cable connection in test Note: There will be a buzzing sound when NSR100W is powered up, and will emit two beeps after 30 seconds. Then NSR100W begins to operate. NSR100W can also be POE powered.
  • Page 8: Frequently Asked Questions (Faq)

    Figure 7 NSR100W test interface display Note: Select " data to local check box ".Save in the top right corner of the test interface. The target data captured by the radar will be stored in the Data folder in the path folder of the MMW Radar Universal Management Tool in text format.
  • Page 9 Hunan Nanoradar Science and Technology Co., Ltd. Tel.: +86-731-88939916 No.27 Wenxuan Road, Hi-tech District Changsha E-Mail:sales@nanoradar.cn B7 Lugu Compark URL: www.nanoradar.cn...