Infrared Remote Control - ELPRO TZ05 User Manual

TZ05

6.0 INFRARED REMOTE CONTROL

The unit is equipped with a receiver for the infra-red remote control. This must be
ordered separately.(Code IRTZ05).
The remote control is of the self-learning type. After inserting the batteries
and each time these are changed, press the "Set" key for a few seconds
IR remote control reception is enabled and disabled
holding down the MODE button of TZ05 at power-on
The TZ05 is factory set with the remote control enabled
The following functions can be carried out using the IR remote control:
Save + IN 1÷4
Recall + OUT 1÷4 Recall a configuration (together with the OUT keys 1÷4)
Recall of a preset from the keypad, from computer or using
the remote control also sets the same configuration as restart
IN keys 1÷4
OUT keys 1÷4
A, V, A+V, Lock
MUTE ON OFF
The INPUTS-OUTPUTS sequence must be complied with also using the
remote control, i.e. select first of all the source and then the destination.
WARNING
WARNING
Save a configuration (together with the IN keys 1÷4)
WARNING
Input selection
Output selection
Setting of switching mode
Sets Mute on the monitoring audio output
WARNING
4X4+1 VIDEO AND AUDIO MATRIX
(or selection N° Save )
(or selection N° Recall)
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210
8