Local Control - ELPRO TZ05 User Manual

TZ05

5.0 LOCAL CONTROL

5.1 Switching of the signals
The 4 video and audio outputs of the unit and also the video and audio preview
outputs can be controlled from the console on the front panel.
The "MODE" button is used to select operating mode:
-Audio only
-Video only
-AFV
-Lock
To perform switching, the INPUTS-OUTPUTS sequence must be complied with,
i.e. first of all select an input and then the output to which to switch the input
selected. As regards operations:
the 4 buttons with built-in led called "INPUTS" are used to select a source. When
a source is selected, it is immediately switched to the PREVIEW output.
the 4 "OUTPUTS" buttons are used to switch the previously selected input to the
output desired.
If AFV (Audio follows video) MODE has been set, the video and audio of the input
are switched to the preview output and then to the output desired; when working
in "video only" mode, only the video is switched. The same applies when working
in "audio only" mode.
Machine status is monitored on the led type matrix on the front panel of the unit.
The color of the led indicates the type of signal on the output:
-green
-red
-orange
Video).
4X4+1 VIDEO AND AUDIO MATRIX
(green led on)
(red led on)
(both leds on)
(both leds off, keypad locked).
indicates audio
indicates video
indicates audio and video (AFV or Audio Follows
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210
6