Set Up Rain Gauge; Set Up Base Station; Connect Ac Adapter; Verify Connection - Oregon Scientific WMR86NSX User Manual

SET UP RAIN GAUGE

The rain gauge collects rain and takes rainfall readings.
The sensor can remotely transmit data to the base station.
To set up the rain gauge:
1. Remove screws and slide the cover off in an upwards
motion.
2. Insert the batteries (2 x
UM-3 / AA), matching the
polarities (+ / -). Press
RESET after each battery
change.
3. Remove the fibre tape.

SET UP BASE STATION

NOTE Install batteries in the remote sensors before the
base station matching the polarities (+ and -).
1. Slide open the battery door.
2. Insert the batteries, matching the polarities (+ / -).
3. Press RESET after each battery change.
4. Close the battery door.
NOTE Do not use rechargeable batteries. It is
recommended that you use alkaline batteries with this
product for longer performance.
NOTE Batteries should not be exposed to excessive
heat such as sunshine or fire.
The battery icon indicator
following areas:
AREA
Weather Forecast Area
Temperature or
Humidity Area
WMR86NSX_IM_EN R10.indd 5
may appear in the
MEANING
Battery in the base station
is low.
The displayed channel
indicates the outdoor
sensor for which battery
is low.
5
Wind Speed / Wind
Battery in the wind
Direction / Wind Chil
sensor is low.
Area
UVI / Barometer / Battery in the UV / Rain
Rainfall Area sensor is low.

CONNECT AC ADAPTER

Connect the supplied power adapter to the power jack,
then plug into a standard AC outlet.
NOTE
• The batteries are only for back-up use. Always connect
the unit to the power grid source via AC/DC adapter.
• Make sure the adapter is not obstructed and is easily
accessible to the unit.
• The base station and adapter should not be exposed
to wet conditions. No objects filled with liquid, such as
vases, should be placed on the base station and adapter.
• To completely disconnect from power, unplug adapter
from the mains.

VERIFY CONNECTION

Before proceeding to install sensors outside, please verify
communication to the base station.

WIND SENSOR

Press SELECT until the selected area icon
middle display area.
• Wind speed: Gently rotate the wind vane and confirm
a numerical reading on the base station, e.g.,
• Wind direction indicator. Move the direction of the
wind indication and verify the icon moves in the same
direction .
is in the
.
2018/9/20 上午11:52