Smeg A2-6 Instructions For Installation And Use Manual page 15

Instructions for the user
-
When the end of the cooking time is reached, the timer will switch off the
oven heating elements, the beeps will start and the numbers on the dial will
flash.
-
The cooking time can also be reset by deleting the program set; pressing
the central key
will have to be switched off by hand.
Caution: cooking times of more than 6 hours cannot be set.
Cooking start: as well as setting a cooking duration time, the user can also set
the cooking start time (up to 12 hours after the current time). To set the cooking
start/end time, proceed as follows.
-
Set the cooking duration time as described in the previous point.
-
Within 6/7 seconds after the last time the
the key to set the cooking start time. The display will show the current time
with the inside segments indicating the cooking end time illuminated. Use
the and keys to set the cooking start time.
-
6/7 seconds after the last time a key is pressed, the display will show the
current time and the cooking start and end times, indicated by the
illuminated inside segments. The segments on the display will be constantly
on until the current time is the same as the cooking start time; as soon as
the current time reaches the cooking start time set, all the inside segments
will start to flash, indicating that the oven has started cooking.
-
When the end of the cooking time is reached, the timer will switch off the
oven heating elements, the beeps will start and the numbers on the dial will
flash.
-
To reset the entire program set, keep the central key
seconds: if cooking has already started the oven will have to be switched off
by hand.
-
The image on the right shows an example of
programming: the current time is 7.06 and cooking is
programmed to start at 8 o'clock and finish at 9.
-
At 8 o'clock, the inside segments between 8 and 9
will start to flash and the hour pointer will remain still.
Caution: for the oven to start cooking after the programming procedure just
described, the thermostat and function selector must be properly set on the
temperature and function required.
5.2.4 "DEMO" Function
Models with analogue/digital programmer feature a "DEMO" function which
deactivates the heating elements while leaving the other functions
unchanged. To activate it, simply press the
them held down for 3-4 seconds. A confirmation buzzer will inform the user
that the function is active. When the "DEMO" function is active, the number 6
on the clock flashes at regular intervals. To deactivate it, simply repeat the
same procedure.
for 1 or 2 seconds will delete the time set and the oven
or keys are pressed, press
pressed for 1 or 2
, , and keys and keep
51