Installation Diagram - Mitsubishi Electric MSZ-AP22VG(K)D Installation Manual

1-4. INSTALLATION DIAGRAM

ACCESSORIES
Check the following parts before installation.
<Indoor unit>
(1) Installation plate
(2)
4 × 25 mm
(3) Wireless remote controller
Felt tape
(4)
(For left or left-rear piping)
(5) Remote controller holder
Fixing screw for (5) 3.5 × 16 mm
(6)
(7)
(8)
<Outdoor unit>
(9)
(8)
(7)
*2 100 mm or more when front and sides
of unit are clear
*3 When any 2 sides of left, right and rear of unit are clear.
Appearance of the outdoor unit may differ from some models.
IMPORTANT NOTES
Units should be installed by licensed contractor according to local code requirements.
To comply with the requirements of Australian standard AS/NZS 3000 electrical
installations (wiring rules), the electrical wiring required between the indoor and
outdoor units must be installed by a licenced electrical contractor.
Check that cabling will not be subject to wear, corrosion, excessive pressure,
vibration, sharp edges or any other adverse environmental effects. The check shall
also take into account the effects of aging or continual vibration from sources such as
compressors or fans.
PARTS TO BE PROVIDED AT YOUR SITE
(A) Indoor/outdoor unit connecting wire*1
1
Extension pipe
5
(C) Wall hole sleeve
1
Wall hole cover
(E)
1
(F) Fixing screw for (E) 4 × 20 mm
1
(G) Piping tape
(H) Putty
2
2
(I) (or soft PVC hose, 15 mm inner
2
diameter or hard PVC pipe VP16)
(J) Refrigeration oil
(K) Power supply cord*1
1
(1)
(2)
(D)
(4) (C)
(G)
(E)
(3) (5)
(F)
(6)
(K)
(B)
(A)
Note:
1
*1 Place indoor/outdoor unit connecting wire (A) and
1
power supply cord (K) at least 1 m away from the TV
1
antenna wire.
1
2 to 5
2 to 5
1
1
1 or 2
1
1
to prevent indoor/outdoor connect-
ing wire (A) from contacting metal
parts in the wall and to prevent
damage by rodents in case the
wall is hollow.
indoors.
When the piping is to be attached to a wall containing metals (tin plated) or metal
netting, use a chemically treated wooden piece 20 mm or thicker between the
wall and the piping or wrap 7 to 8 turns of insulation vinyl tape around the piping.
To use existing piping, perform COOL operation for 30 minutes and pump
dimension for new refrigerant.
Outdoor unit installation
150 mm
(I)
2-10 mm × 21 mm slot
(9)
Note:
Install the unit horizontally.
fan stop.
The outdoor unit produces condensate during the heating operation. Select
the installation place to ensure to prevent the outdoor unit and/or the grounds
from being wet by drain water or damaged by frozen drain water.
Indoor unit
Wall hole
sleeve (C)
Cut off the
extra length.
WARNING
After the leak test, apply insulating material tightly
so that there is no gap.
WARNING
800 mm
500 mm
Air inlet
Air outlet
40 mm
Drain piping for outdoor unit
ing connection.
illustration.
(I)
Seal the wall hole
gap with putty (H).
Fix the pipe to wall
(E).
Fixing screw (F)
-