HAGER WERKEN SPEED LABOLIGHT Instruction Manual page 3

3.a Putting into Operation:
• Adjust main switch to position 1 (on).
• Open the device by lifting the door.
• P lace the object to be polymerized onto the turntable. If necessary, use special holder. Make sure
that the object is set up vertically near the lamps.
• Close the door.
• Push button 3 (MENU) and select:
1: the polymerization time in minutes. To modify the selected value, push buttons 4. When the
chosen value is visualized, push button 3 (MENU) again to confirm and move on to the follow-
ing phase.
2: the final cooling time in minutes – the length of time the cooling fan should stay on at the end
of the process (minimum 1 minute). Select the desired time with buttons 4 and push button 3
(MENU) again to confirm and move on to the following phase.
3: if you want to select a process with or without the HALOGEN lamp. (1=NO , 2=YES to move
from 1 to 2 use buttons 4). Push button 3 (MENU) again to exit programming.
At this point, the device is ready to perform the polymerization process.
• Press button 2 (START).
• Make sure the object does not come into contact with the lamp group.
• Wait for the end of the polymerization process and also for final pre-set cooling time.
• Open the door and remove the object.
• I n case you need to remove the object during the polymerization process, press button 2 (START)
and open the door manually.
• I f the door is opened during a polymerization process without following the above instructions,
the process will come to a halt, but the device will execute the final pre-set cooling time.
3.b Language setting:
Press the "-" button and switch on the unit. The display shows the pre-set language. The language
can be changed by pressing the "-" button until the required language shows up. Choose between
German, Italian, English and French.
3