Table of Contents
Advertisement
B A CK P ANE L
A
B
C
D
A
Analog Phono Ports Connect to analog amp
B
RS232 Phoenix Ports 0V = Zero volts (GND). TX is signal coming out of matrix
(from remote device) RX is signal going into matrix (to remote device).
C
IR Receiver and Transmitter Ports Use the supplied IR emitters and plug into the 'IR Out'
ports for the relevant source (i.e HDMI Input 2 will use IR Our 2). The IR Emitter is to be
mounted with the sticky pad horizontally over the source device's infrared sensor window
Please see fig2 for correct identification and installation.
D
HDBaseT Outputs Connect your sink devices Connect the appropriate Cat5e or higher
grade cable to each output, these cables should be attached to the receiver at the sink
end
(i.e. TV/amplifier etc)
E
HDMI Inputs Connect your source devices via a high speed HDMI cable
F
Global IR Used for a control systems to see all IR signals from all zones. Zektor Optocables
are recommend for connectivity from this port to your control system
G
HDMI Outputs Connect high speed HDMI cables to each output, these cables should
be attached directly to local sink devices
H
Ethernet Connect to your router using a standard Cat5e (or higher grade) cable to provide
internet access to the matrix. This will allow you to receive automatic updates and remote
monitoring services. This system is designed to be connected to the internet at all times.
I
Digital Optical and Coax Ports Connect to digital amp
IR B U D S
The IR Emitter is to be mounted over the
source's IR window. The IR Receiver bud
should be mouted underneath the sink
(TV) with the smallest end forwards and
the sticky pad affixed upwards.
4
E
F
G
H
IR Receiver
IR Emitter
Square with a
Identified by a
shiny surface
matt surface
FRONT PAN EL
I
J
System Health LED When the system is running correctly, the LED will light green
K
Network LED When the system is connected to the network, the LED will light green
L
Cloud LED When the system is connected correctly to the online monitoring cloud, the
LED will light green
RECEI VERS
1
1
HDBaseT Input Connect to the matrix input via Cat5e or higher grade cable
2
HDMI Output Connect directly to the sink device (i.e. TV) using a HDMI cable
3
Ethernet Allowing Ethernet passthrough
4
IR Activity LED Indicates when an IR signal is being received
5
IR TX Allows transmitted IR signals to be fed to local devices (i.e. amp)
6
IR RX Connect the supplied IR receivers to this port, the shiny part is to be attached to the
fig2
sink device (TV) this bud is designed to be placed underneath the edge of the device with
the sticky pad upwards. The short edge of the Receiver should be facing outwards under
the device. Please see fig2 for correct identification and installation.
7
RS232 Jack Connect adapter for serial (adapter not included)
8
Analog/Optical Connect mini-TOSLINK / Analog adapter (not included)
2
3
4
5
6
J
K
L
7
8
5
Advertisement
Table of Contents
