Emerson Bettis RTS FL Series User Instructions page 59

User Instructions
MAN-02-04-60-0352-EN Rev. 3
Table 18.
P10.1
Parameter Menu
Binary Outputs Table (3)
Menu Sub Menu
Item Item
40: Fail-safe
41: Fail-safe
42: Fail-safe
Ready/Torque
Ready/Remote/
Torque OK
Position=Int1
Position=Int2
Position=Int3
Position=Int4
50: Position
= Emergency
Binary
Output 1
Output
51: Bus Bit 1
52: Bus Bit 2
53: Bus Bit 3
54: Bus Bit 4
55: Bus Bit 5
56: Bus Bit 6
57: Bus Bit 7
58: Bus Bit 8
59: Virtual 1
60: Virtual 2
61: Virtual 3
62: Virtual 4
63: Line voltage
64: Control
voltage OK
65: Oil pressure
66: Oil level OK
67: Pump OK
Position
Setting
Fail-safe OK (only for fail-safe actuators)
OK 1
Fail-safe OK and Ready (only for fail-safe actuators)
OK 2
Fail-safe OK, Ready and Remote
OK 3 (only for fail-safe actuators)
43: Lock Lock Open or Lock Closed is enabled.
44:
Actuator is ready and no torque switch off.
OK
45:
Actuator is ready for operation in REMOTE mode and no
46: Position = Intermediate position 1. The width of the
interval is set with the parameter P8.6.
47: Position = Intermediate position 2. The width of the
interval is set with the parameter P8.6.
48: Position = Intermediate position 3. The width of the
interval is set with the parameter P8.6.
49: Position = Intermediate position 4.The width of the
interval is set with the parameter P8.6.
Position = emergency position. The width of the
interval is set with the parameter P8.6.
Position
In existing bus interface (hardware option) the
output is set according to the selected bit bus.
Configurable output function.
Supply voltage for the motor is OK.
OK
The auxiliary voltage for the SMARTCON control is
OK. This function is only available if the auxiliary
voltage output is not switched on (P6.5 to 0).
The oil pressure is higher than the minimum
OK
The temperature sensor in the pump motor and the
external motor protection have not tripped.
Section 8: Parameter Menu
February 2019
Notes/Comments
torque switch off.
pressure (P6.10)
The oil level is OK.
54