Panasonic TY-ST43PE8 Operating Instructions Manual page 17

Assembly Procedure
2. Attaching the pedestal bracket
Attaching to LF8/LF80 series (Display)
This procedure is unnecessary.
1) Place the pedestal brackets
back of the display.
2) Fix with the 6 display installation screws
Tightening torque: 1.2 to 1.5 N•m
Note
● Always use the specified holes to attach the pedestal.
3. Attaching the base
Attaching to LF8/LF80 series (Display)
The back of the display is combined with the brackets.
Attach the pedestal base in the same way.
1) Insert the base to the pedestal bracket
● The surface with the label goes to the back of the
display.
● Be careful not to drop.
2) Fix the base with 2 base installation screws
● Assemble the 2 overturn-prevention belts
with the base installation screws
Tightening torque: 1.2 to 1.5 N•m
3) To stand the display vertically.
● Make sure to hold the display with more than two
people.
to fit the holes at the
.
.
Label
together
.
(Cont'd)
Pedestal bracket
.
Overturn-prevention
belt
Display installation screw
Base installation screw
Base
17