Safety Instructions; Personal Safety Precautions - Solar 3001 Owner's Manual

Commercial jump starter
Hide thumbs Also See for 3001:
Table of Contents

Advertisement

SAFETY INSTRUCTIONS

1. Use of an attachment not recommended or sold by manufacturer may result in a risk of fire, electric shock,
or injury to persons.
2. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting unit.
3. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage
or stress.
Read these instructions completely before using the SOLAR Jump Starter/Charger and save them for future
4. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could
reference. Before using the SOLAR Jump Starter/Charger to jump start a car, truck, boat or to power any
result in a risk of fire and electric shock. If an extension cord must be used, make sure pins on plug of
equipment, read these instructions and the instruction manual/safety information provided by the car, truck,
extension cord are the same number, size, and shape as those of plug on unit; extension cord is properly
boat or equipment manufacturer. Following all manufacturers' instructions and safety procedures will reduce
wired and in good condition; wire size is large enough for the length of cord as specified in the following
the risk of accident.
chart:
Working around lead-acid batteries may be dangerous. Lead-acid batteries release explosive gases during
normal operation, charging and jump starting. Carefully read and follow these instructions for safe use. Always
Length in feet:
follow the specific instructions in this manual and on the SOLAR Jump Starter/Charger each time you jump
Cord AWG size:
start using the SOLAR Jump Starter/Charger.
5. Do not operate unit with damaged cord or plug - replace them immediately.
All lead-acid batteries (car, truck and boat) produce hydrogen gas which may violently explode in the presence
of fire or sparks. Do not smoke, use matches or a cigarette lighter while near batteries. Do not handle the
6. Do not disassemble unit – take it to/or call a qualified technician when service or repair is required.
battery while wearing vinyl clothing because static electricity sparks are generated when vinyl clothing is
Incorrect reassembly may result in a risk of electric shock or fire.
rubbed. Review all cautionary material on the SOLAR Jump Starter/Charger and in the engine compartment.
7. To reduce risk of electric shock, unplug unit from outlet before attempting any maintenance or cleaning.
Always wear eye protection, appropriate protective clothing and other safety equipment when working near

PERSONAL SAFETY PRECAUTIONS

lead-acid batteries. Do not touch eyes while working on or around lead-acid batteries.
Always return clamps to their proper storage positions, away from each other or common conductors. Improper
1. Someone should be within range of your voice or close enough to come to your aid when you work near
storage of clamps may cause the clamps to come in contact with each other, or a common conductor, causing
a lead-acid battery. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing
the battery to short circuit and generate high enough heat to ignite most materials.
or eyes.
Never touch the air compressor or fittings connected to the air compressor, with bare hands during or
2. If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye,
immediately after usage. It will become very hot during and after use, if necessary, wear heat resistant gloves.
immediately flood eye with running cold water for at least 10 minutes and get medical attention immediately.
Use extreme care while working within the engine compartment, because moving parts may cause severe
3. NEVER smoke or allow a spark or flame in vicinity of battery or engine.
injury. Read and follow all safety instructions published in the vehicle's Owner's Manual.
4. Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery
or other electrical part that may cause explosion.
The battery in the SOLAR Jump Starter/Charger contains liquid acids which are hazardous if spilled. In
addition, batteries being charged with the SOLAR Jump Starter/Charger unit likely contain liquid acids which
5. Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a
are hazardous if spilled.
lead-acid battery. A lead acid battery can produce a short circuit current high enough to weld a ring or
the like to metal, causing a severe burn.
6. When using unit as charger, charge a LEAD-ACID battery only. It is not intended to supply low-voltage
power for applications other than battery charging. Do not use with batteries that are commonly used
with home appliances. These batteries may burst and cause injury to persons and damage property.
7. NEVER JUMP START OR CHARGE a frozen battery. Any battery that is suspected of being frozen must
be thawed before jump starting or charging.
DO NOT TIP UNIT OR LAY UNIT FLAT WITH BATTERY INSTALLED!
GROUNDING AND AC POWER CONNECTION INSTRUCTIONS
Unit should be grounded to reduce risk of electric shock. Unit is equipped with an electric cord having an
equipment grounding conductor and a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
Never alter the AC cord or plug provided – if it will not fit outlet, have proper outlet installed by a qualified
electrician. This unit is for use on a 120 Volt, 60 Hz cycle circuit. A temporary adapter may be used to connect
this plug to a two-pole receptacle if a properly grounded outlet is not available. The temporary adapter should
be used only until a properly grounded outlet can be installed by a qualified electrician. Before using adapter,
be certain that center screw of outlet plate is grounded. The green rigid ear or lug extending from adapter must
be connected to a properly grounded outlet – make certain it is grounded. If necessary, replace original outlet
cover plate screw with a longer screw that will secure adapter ear or lug to outlet cover plate and make ground
connection to grounded outlet.
WARNING
25
50
100
150
16
12
10
8
WARNING
DANGER

Advertisement

Table of Contents
loading

This manual is also suitable for:

2001

Table of Contents