Portable jump starter with 12 volt power and led flashlight (17 pages)
Summary of Contents for Solar HT1224
Page 1
Owner’s Manual Model Nos. HT1224/FMB1224 Commercial Jump Starter/Chargers WARNING WARNING - 12/24 VOLT MODELS READ ENTIRE MANUAL Never hook up a 12 Volt DC power source to a 24 Volt DC vehicle. This will CAREFULLY BEFORE grossly overcharge the 12 Volt power source and generate flammable OPERATING UNIT! gasses that may explode and cause property damage and/or bodily harm.
Page 2
WARNING Read these instructions completely before using the SOLAR Jump Starter/Charger and save them for future reference. Before using the SOLAR Jump Starter/Charger to jump start a car, truck, boat or to power any DANGER equipment, read these instructions and the instruction manual/safety information provided by the car, truck, Never alter the AC cord or plug provided –...
Read these instructions completely before using the SOLAR Jump Starter/Charger and save them for future reference. Before using the SOLAR Jump Starter/Charger to jump start a car, truck, boat or to power any chart:...
Page 4
UNIT ASSEMBLY AND SETUP CHARGING INSTRUCTIONS Batteries have already been installed in units and are ready for immediate use. We recommend charging the unit upon receiving, so you will have maximum power for your jumping needs. 1. Unwrap AC power cord from unit and plug into 120VAC outlet. 2.
READ ENTIRE MANUAL Never hook up a 12 Volt DC power source to a 24 Volt DC vehicle. This will CAREFULLY BEFORE grossly overcharge the 12 Volt power source and generate flammable OPERATING UNIT! gasses that may explode and cause property damage and/or bodily harm. OPERATING INSTRUCTIONS WARNING - 12/24 VOLT MODELS Never hook up a 12 Volt DC power source to a 24 Volt DC vehicle.
Page 6
4. A high quality battery emits fewer gases as it recharges. Using a high quality battery will extend charger and wiring life. Battery acid and petroleum resistant wiring is used in this unit. Battery fluid level must be checked every 30 to 45 days. BATTERY REPLACEMENT (HEAVY TRUCK HT1224) See Figure 1 REMOVING OLD BATTERIES 1.
Page 7
(Internally, both chargers will have a green LED lit showing charge cycle complete and both chargers in maintain mode.) 15. Replace bottom front panel and secure with the (6) #8 x 1/2” Screws. 16. Replace the faceplate and secure with the (8) #8 x 1/2” Screws. FIGURE 1 – HT1224 WIRING DIAGRAM...
Page 8
BATTERY REPLACEMENT (FIX MOUNT FMB1224) See Figure 2 REMOVING OLD BATTERIES: 1. Open box lid. 2. Disconnect cables and wiring from batteries. 3. Loosen hold-down by removing 1/4–20 bolt on end of box, by vehicle harness. This will allow hold-down to pivot up.
For best service and to receive periodic product updates, please visit www.cloreregistration.com, click on the SOLAR brand link, complete the information in the web form and click “submit.” It’s that easy! For answers to questions concerning use, out-of-warranty service, or warranty/service information on this or other Clore Automotive products, contact Clore Automotive Technical Service at 800.328.2921;...
Page 12
Ne manipulez jamais une batterie si vous portez des vêtements en vinyle car des étincelles d'électricité statique chargement des batteries au plomb-acide de 12 volts. Suivez toutes les instructions du manufacturier pour le se produisent au frottement du vinyle. Lisez attentivement tout avertissement figurant sur le SOLAR et sur le démarrage d’urgence et le chargement.
INSTRUCTIONS DE SÉCURITÉ 1. N’utilisez jamais un accessoire non recommandé ni vendu par le fabricant du chargeur de batterie pour ce modèle particulier. 2. Branchez et débranchez toujours le cordon d’alimentation en tirant sur la fiche et non pas sur le cordon, pour éviter de l’endommager.
Page 14
NE PAS RENVERSER OU COUCHER À PLAT L'UNITÉ AVEC UNE BATTERIE INSTALLÉE ! DANGER Ne jamais modifier le cordon électrique C.A. ou la prise incluse, ils ne sont pas compatible avec la prise de courant, faites installer une sortie appropriée par un électricien qualifié. Cette unité sert sur un circuit de 120 volts avec cycle de 60 Hz.
Page 15
Ne manipulez jamais une batterie si vous portez des vêtements en vinyle car des étincelles d'électricité statique se produisent au frottement du vinyle. Lisez attentivement tout avertissement figurant sur le SOLAR et sur le 5. Brancher la pince (rouge) POSITIVE de l’unité à la borne POSITIVE (position, P, +) (sans prise de terre) de compartiment du moteur.
Page 16
Un câblage résistant à l’acide de batterie et au pétrole est utilisé dans cette unité. Le niveau du fluide de la batterie doit être vérifié tous les 30 à 45 jours. REMPLACEMENT DE LA BATTERIE (CAMION LOURD HT1224) Voir le Schéma 1 ENLÈVEMENT DES VIEILLES BATTERIES...
Page 17
15. Remettez le panneau avant inférieur et fixez-le avec les (6) vis nº 8 x 1/2”. 16. Remettez la façade et fixez-la avec les (8) vis nº 8 x 1/2”. HT1224, 12/24 CAMION LOURD - LE SCHÉMA 1...
Page 18
REMPLACEMENT DE LA BATTERIE (SUPPORT STATIONAIRE FMB1224) Voir le Schéma 2 ENLÈVEMENT DES VIEILLES BATTERIES : 1. Ouvrez le couvercle de la boîte. 2. Débranchez les câbles électriques et les fils des batteries. 3. Deserrez l’attache à l’extrémité de la boîte en enlevant le boulon 1/4-20, près du faisceau du véhicule. Ceci permettra à...
DÉPANNAGE PROBLÈME CAUSE POSSIBLE SOLUTION Le démarrage Les connexions rapides ne sont pas Vérifiez les connexions rapides d'urgence ne attachées ensemble Vérifiez les pinces fonctionne pas Mauvais branchement des pinces Chargez, vérifiez/changez la batterie Une batterie faible et défectueuse Nettoyez et resserrez les raccordements de Une connexion relâchée des câbles de la batterie démarrage d'urgence à...
GARANTIE LIMITÉE Clore Automotive, L.L.C. garantit que, pour une période de 1 ans à partir de la date d’achat initial pour l’appareil tout entier, ce produit sera réparé gratuitement (pièces et main-d’œuvre) s’il est jugé défectueux en raison de défauts de matériaux ou de fabrication. Si, malgré les efforts raisonnables de Clore Automotive, le produit s’avère irréparable, Clore Automotive aura l’option soit de rembourser le prix d’achat initial soit de fournir un appareil de remplacement.
Page 24
Owner’s Manual Model Nos. HT1224/FMB1224 Commercial Jump Starter/Chargers READ MANUAL CAREFULLY BEFORE OPERATING UNIT! WARNING: This product contains chemicals, including lead, known to the State of California to cause cancer, birth defects and other reproductive harm. Wash hands after handling.