Power Data Gateways In Cluster Installations - solarwatt MYRESERVE MATRIX Installation And Operating Instructions Manual

Power Data Gateways in cluster installations

On systems using more than one MyReserve Command,
connect the PDGs sequentially, as follows:
PDG
1
Hostname
Bluetooth
2
connection
Default
3
setting
Subject to change | © 2018 SOLARWATT GmbH | AZ-TM-PME-1182 | Rev 004 | Version: 01/2018
1
2
3
By default, PDGs are delivered with the network name solarwattgw. Call the PDG web
server up in the browser using the PDG hostname.
Give each PDG in the cluster installation a separate name, and note these names
down for later, to ensure unique assignment of each PDG.
In cluster installations, you can set which MyReserve you want the currently active
PDG to connect to. To select a MyReserve, enter its Bluetooth name. You can find the
name on the MyReserve Command (Fig.).
MyReserve Bluetooth name
MyReserve serial number
Clicking ok here will restore the default no special binding setting, meaning the
Bluetooth connection to a MyReserve will be disconnected again.
Step 1: Connect MyReserve Command 1 to PDG 1
Step 2: Connect MyReserve Command 2 to PDG 2
EN
Page 43