Table of Contents
Advertisement
TROUBLESHOOTING
Problem
Abnormal heavy vibrations
Bad cuts
Noise in the pole
Tool does not start
Tool suddenly stops
Cause
Improper mounting of the blade
Blade adjustment too important
Blade wear
Deteriorated pole guide
Battery drained
No power to the tool
Others
Too much pressure on the branches.
Battery drained
Diameter of branches too large
20
Solution
Disassemble and reassemble the blade
following the procedure
Set the blade adjustment following the
procedure and contact your dealer if
necessary
Change the worn blade following the
procedure.
Contact your dealer
Recharge the battery
Reconnect to power source
Contact your dealer
Do not force on the tool
Recharge the battery
Cut branches with a diameter smaller
Advertisement
Table of Contents
