Get Your Device Ready; Charge The Battery; Install The Battery; Turn The Device On - Kyocera Rise Basic Manual

Get Your Device Ready

Find out what you need to do before you use your
device the first time.

Install the Battery

1. Hook your thumb- or fingernail into the slot at
the left side of the battery compartment cover
( ) and gently lift up to remove the cover
( ).
2. Insert the battery, contacts end first, and gently
press into place (
3. Make sure the locking tabs of the cover are
seated and then gently press the cover (
).

Charge the Battery

1. Plug the smaller end of the micro-USB cable
into the device's charger/accessory jack.
2. Plug the other end of the USB cable into the
charger, and then plug the charger into an
electrical outlet.

Turn the Device On

).
 Press and hold the Power button to turn your
device on.
Power Button
Get Started 3