Smeg ST144 Instruction Manual page 8

Smeg dishwasher instruction manual
Table of Contents

Advertisement

SWITCHING OFF
The end of the washing program is signalled by a short intermittent beep and the
appearance of "P0" on the DISPLAY.
ANNULLING THE PROGRAM IN PROGRESS
To annul the program being carried out, after opening the door select program "P0".
When the door is closed the dishwasher will skip to the end of the program.
MODIFYING THE PROGRAM
To modify the current program, after opening the door select the new program.
When the door is closed the dishwasher will start the new program automatically.
DELAYING THE PROGRAM
The start of the washing program can be delayed from a minimum of 1 hour to a
maximum of 9 hours; this allows you to operate the dishwasher at the time of day of
your choice.
When the DELAYED START button (3) is pressed, the DISPLAY (6) will show first the
duration of the program set and then the number of hours (9,8, ...1) of delay with which
it is to be started.
The
symbol will remain until the start of the washing cycle, while the number of hours
will disappear automatically if the keypad is not used for 5 seconds or if any other button
except the DELAYED START button (3) is pressed.
When the door is closed the dishwasher will perform a pre-wash, after which the
"program delay" set previously will start. To check the time left before the program
starts, simply press the corresponding button once.
If it is necessary to open dishwasher door during the washing cycle, there
will be a 1-minute delay before the program can be resumed.
After correctly closing the door, the washing program will start again from
where it was interrupted. This operation may negatively affective the
progress of the washing cycle.
TABLE FOR CERTIFICATION BODIES
Reference standard
Reference program
Load
Type of detergent
Amount of detergent
Rinse aid setting
EN 50242 STANDARD LOADS
LOWER BASKET
The cutlery basket disposes of an exclusive system of indipendent sliding flap
inserts; some combinations permit to make the best of the available space.
Vertical
inserts
EN 50242
(*) ECO BIO program (5)
14 place-settings
B
30 g
Depending on the model 3/4 or 4/6
UPPER BASKET
Movement required
to extract the inserts
Horizontal
insert closed
Horizontal
insert
open

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stx1cStx2lbStx2saStx2sbStx6sWt144

Table of Contents