Storage - Ford FPXD30E Operator's Manual

Storing Trash Pump
Proper storage prevents the development of rust and corrosion which affects the pumps performance and appearance.
Proper storage also makes it easier to start the engine when using the pump again. If storing water pump for 30 days or
more follow the below procedures:
If pump has been running, allow engine to cool for at least 30 minutes before taking the steps
CAUTION!
CAUTION!
mentioned below to avoid damage to pump.
Clean Pump
• If pump has been running, allow engine to cool to avoid damage to engine.
• Hand wash pump and engine. Keep water from areas difficult to dry, from controls, and from muffler or air cleaner
openings. Avoid using a garden hose or pressure washer as it could cause water to enter the air filter or muffler and can
damage the cylinder and filter.
• Wipe dry all accessible surfaces to prevent rust.
Fuel Stabilizer
• For short term storage (30-90 days) add a fuel stabilizer to the diesel to keep diesel from going stale and to prevent
gum deposits from forming on the carburetor. Run engine for about 10 minutes to circulate the fuel stabilizer.
If fuel stabliizer is not used, drain fuel tank and fuel injection pump assembly (See pg.17 ).
•
WARNING!
WARNING!
Flush Pump (See Fig 14)
• Place the pump outdoors on a level surface.
• Fill the pump with fresh, clean water and start the engine. Let pump run several minutes to allow the external water to
evaporate.
• Once the engine is warm, turn engine off and allow it to cool.
• Remove Drain Plug and flush pump with fresh, clean water.
• Let water drain from the pump chamber then reinstall Drain Plug.
Warranty does not cover engine damage caused by failing to properly store pump. Diesel can
deteriorate in months. Failure to drain fuel or use a fuel stabilizer may require you to service or
replace the Fuel pump or other fuel system components.

STORAGE

PUMP DRAIN PLUG
(CLEAN OUT PORT)
Fig 14
16