Smeg PL4107NE1 Instruction Manual page 17

To reset or change the delay once the program has started:
•
press
PHASES/PROGRAM lights (8) come on;
•
press the DELAY PROGRAM button (3
program delay" returns to zero (all the lights indicating the delay go
out);
•
press
To set the delay once the program has started, proceed as follows.
If the program you wish to carry out is the same as the one already
in progress:
•
press
PHASES/PROGRAM lights (10) come on;
•
annul the program in progress (see relative
cycle to come to an end;
•
select the program again;
•
select the delay required;
•
press the START/PAUSE
If the program you wish to carry out is different from the one
already in progress:
•
press
PHASES/PROGRAM lights (10) come on;
•
change the program;
•
select the delay requir
•
press the START/PAUSE
dishwahser will pump out the water and restart with the delay set
and the new program.
16
User instructions
the START/PAUSE button (4) for a few seconds, until the
the START/PAUSE button (4) to start the new program.
the START/PAUSE button (5) for a few seconds, until the
the START/PAUSE button (5) for a few seconds, until the
ed;
) several times "until the
section) and wait for the
button (5) to start the new program.
button (5) to start the new program. The