Table of Contents
Advertisement
User instructions
SELECTION PROGRAM
When the button relating to the program required is pressed, the relative
light will come on to confirm the operation.
To run the last four programs in the table, first select the "main" program
(P2, P3, P4, P5) and then the soak program P1.
START PROGRAM
To start the dishwasher, press the START/PAUSE button (4) for a few
seconds, until the light of the first phase of the selected program starts to
flash (confirmation beep).
This phase, that updates itself during the cycle, is "indicative" since it is
influenced by the washing conditions such as dishwasher type and
quantity, entry temperature etc. For this reason it is normal to see the
updating during a program (increment and decrease of minutes)
specially in the passage from one phase to the other (for example, from
washing to rinse).
As the program runs, the PHASES/PROGRAM lights (8) will indicate the
current cycle status.
The program selection is possible
through the relative buttons (2).
The light of the phase in progress will
flash, while the lights of the previous and
subsequent phases remain on.
N.B. during execution of programs which
do not include a prewash, the first
PHASES/PROGRAM light (8) will remain
off.
13
Advertisement
Table of Contents
