Evaluation Board Specifications - National Semiconductor ADC122S101 User Manual

•
Check to see that the DUT input signal does not go
below ground or above the DUT analog supply
voltage.
•
Be sure that a minimum of +2.7V is at pin 1 of TP1.
•
Be sure that only one clock source (oscillator at Y1
or signal at BNC3) is active on the board.

6.0 Evaluation Board Specifications

Board Size:
Power Requirements:
Clock Frequency Range:
Analog Input
Nominal Voltage:
Impedance:
3.1" x 3.8" (8.0 cm x 9.6 cm)
+ 5.5V to 5.7 @ 15 mA
1 MHz to 20 MHz
Supply peak-to-peak Voltage
50 Ohms
7 http://www.national.com