Washing Programs - Smeg KLVS50EB Instruction Manual

User instructions
TABLE FOR CERTIFICATION BODIES
Reference standard
Reference program
Load
Type of detergent
Amount of detergent
Rinse aid setting

Washing programs

The dishwasher is equipped with a control panel and an 3-FIGURE DISPLAY (6), described in
chapter "1. Description of the controls", from which it is possible to carry out all the power switch-
on, switch-off and programming operations.
Before starting a washing program make sure that:
The water supply tap is open.
•
The correct amount of detergent has been added to the dispenser.
•
The baskets have been correctly loaded.
•
• The spray arms are able to rotate freely and without obstruction.
The dishwasher door is securely closed.
•
HALF-LOAD FUNCTION (available in all programs except the soak program)
This function is recommended for loads of up to 6 place-settings, and cuts down on the use of
water and electricity. It is controlled by the HALF LOAD button (4) and allows washing in the upper
basket only.
IMPORTANT: at the end of the program remember to deactivate the function to ensure the next
wash is not also carried out in half load mode by mistake.
A cutlery basket can be placed in the upper basket, while the lower basket must be left empty.
CAUTION: there is no point in loading dishes and cutlery in the lower basket, since the jet of
water will only reach the upper basket.
EN 50242
(*) Selector on P4
12 place-settings
B
30 g
Depending on the model 3/4 or 4/6